Microed the back edge of the turtle back,
Installed the Clark foam and plates for the rudder pulleys.
.
Inside engine mount reinforcement complete. 8 layers of BID, then the AL hard points then a layer of BID over those. Took about 3 hours to cut the glass, cut and shape the aluminum and glass them in. Not very comfortable. One builder suggested doing the layups in a box, then transferring it. I think I'd do that next time to avoid the discomfort of kneeling, squatting and setting back here.
The front edges need trimmed and sanded. These should be a little more rounded rather than square so here's a few extra ounces of weight. OTOH, it might get used to help support a shelf for equipment that's going to get stuffed in here.
No comments:
Post a Comment