 |
| After sanding the barrier coat, had a few spots that still needed filled. |
 |
| The inside of one of the covers with no fill and little sanding shot with primer. |
 |
| Filling the small nicks, gouges etc. The straight edges of these patches are much easier to feather than a round splotch. |
 |
| Some transition areas still had quite a few low shiny spots. I used a scotch brite pad and recoated with very wet micro, pulled the tape off, let cure, then sanded and feather the areas. |
 |
| Inside of the carbon fiber cowl with a light epoxy wipe and little sanding. The weave texture is present. The inside of the cowls are much easier to wipe clean if they're painted. |
 |
| We had warm enough temps outside to shoot the second coat of primer on the inside of the cowls and arm rests. |
 |
| I sprayed the inside of the canopy with Zolatone "Marble Stone" over one coat of SPI primer that had cured. I used the 1.8 tip (largest I had). The instructions recommended 2.2. |
No comments:
Post a Comment