Sunday, January 13, 2019

2019 01/12

Another chilly day outside.  Not bad inside the hangar.

Tightened some of the firewall motor mount bolts. 
Helped Vance with a few things on his Cozy this afternoon.
This evening, ran some of the SDS wires to the front console:
2 DB 9 cables that go to the programmer
2 blue LOP wires (primary and back up)
Fault LED wire (from primary ECU pin 11)
Shielded 3 conductor mixture knob wires.

Remaining wires that need to run to the front from the hell hole:
Injector selector switch
ECU primary and back up power
Air Brake Actuator
Roll Servo network and power
ELT wires
Dynon  SV-220 (sensors interface unit) network wires
Fuel site gauge illumination LEDs.

Also need to connect and mount the Princeton fuel probe modules.
A Hall Effect amp sensor (on order) will be used instead of a shunt.

No comments:

Post a Comment