I used some 2024T3 angle, nut plates and .063" 90's were used to support the front of the radio stack. The angle is notched to accommodate the Dynon Knob Panels.
Since the engine is pulled and the vent lines were still sticking straight back, it was time to terminate them into the manifold. The left and right vent lines to be fabricated. Some clamps and bolts through the firewall will secure the lines. I'll try to use the same bolts for mounting the master and starter solenoids. Blue tape marked the outline of where the oil filter and pad mount alternator need clearance.
No comments:
Post a Comment